Check and verify that the latest drawing and tile
installation pattern are approved.
Verify that the ceramic tiles, mortar mix, and grout
material are approved, and that the same quality is used on-site.
Ensure that the mock-ups are approved by the
consultant/client.
Ensure that the floor screed or wall plaster (if any) is in
good condition and within the specified tolerances.
Check the alignment, setting out, floor level, and/or wall
plumbness before installing the tiles.
Ensure that the floor/wall area is oil-free, clean, and
dampened to receive the mortar mix, and dry to receive the adhesive.
In wet areas, check that the approved waterproofing is
completed as per the manufacturer’s instructions and tested for leakage (raise
an inspection request).
Verify that the application of the mortar mix to the floor
and adhesive to the wall is done in accordance with the manufacturer’s
instructions.
Check that the ceramic tiles are installed according to the
drawing pattern and the manufacturer’s instructions (ensure that the back of
the tiles receives the correct adhesive coverage to prevent hollow tiles).
Ensure that all corners are properly terminated with
approved corner beads.
Ensure that all services are pressure-tested and accepted.
Verify the square corners at the wall/floor tile termination
area.
Ensure that the grouting is done according to the
manufacturer’s instructions.
Ensure that the ceramic tile surface is accepted.
Ensure that the completed tile area is protected from
traffic.
No comments:
Post a Comment